UB Information Technology

Documentation

ResNet: NETGEAR Router

Documentation print footer; appears at "bottom" of first page.

Adobe Reader 7 for Windows

Platform: Windows

ResNet: NETGEAR Router

Platform: Windows Mac

Introduction

Note

In ResNet, each user should purchase and connect to his or her own router. When multiple users utilize the same router, it is difficult to identify the user responsible for actions such as propagation of viruses.

A firewall is a security system that acts as a protective boundary between your network and the outside world. Attaching a router to a computer allows the computer secure Internet access with an inherent firewall. The University at Buffalo recommends purchasing either the NETGEAR RP614v2 Cable/DSL Router or the Linksys BEFSR41 EtherFast Cable/DSL Router. SNAP computer recipients will receive the Linksys BEFSR11 EtherFast Cable/DSL Router. This document provides instructions for the NETGEAR model. UB recommends that all students on and off campus use a router as a firewall.

The Router

Installing the Router

  1. Insert one end of the Ethernet cable into the Internet port (as labeled above in the section entitled The Router). If you are on campus, insert the other end into the Ethernet wall jack. For DSL and cable modems, insert it directly into the DSL or cable modem.

    Note

    Your computer does not have to be turned off to install the NETGEAR router.

  2. Connect the computer to one of the four numbered Ethernet ports on the router using another Ethernet cable.
  3. Connect the power adapter to the router. Next, plug the adapter into a surge protector.

Configuring the Router

  1. Open a web browser.

    Note

    If you live in the Residence Halls or Campus Apartments, follow the steps for configuring your computer for ResNet first.

  2. In the Address box, enter http://192.168.0.1 and press Enter or Return.
  3. Enter admin and password into the User name and Password fields, respectively. Click OK.
    User name admin and default password password
  4. The Setup Wizard will appear. Select Yes to have the Setup Wizard automatically configure the router. Click Next.
  5. Please wait while the Setup Wizard attempts to configure your router.

    6. Note

    The configuration instructions are designed to work for on-campus use. They may or may not work for other Internet Service Providers (ISPs). Contact your ISP for configuration information, or refer to your router's instruction manual.

  6. Click Done.
  7. Keep the default settings and click Apply.
  8. In the left-hand column under Maintenance, select Set Password.
  9. Enter password into the Old Password field. Enter a new, secure password in the New Password and Retype New Password fields. Click Apply.
    Set Password
  10. You will receive confirmation that your password has been changed.
    Password was successfully changed
  11. Enter admin in the User name field and your new password in the Password field. Click OK.
    User name and new password

Your NETGEAR router should now be properly configured for use.

Related Documents

Document Information

Title: ResNet: NETGEAR Router
Document Category: WIN
Document Number: WIN-035

Did this page answer your question?

Yes, it did. No, I'm looking for something else.

For further technical assistance, please contact:

CIT Help Desk
214 Lockwood
Lockwood 2nd Floor Cybrary
(716) 645-3542
cit-helpdesk@buffalo.edu
http://helpdesk.buffalo.edu/